DIY Shooting Sticks


Posted on December 5th, by Michael in Advice, DIY, Gear, Precision Rifle. 1 Comment

DIY Shooting Sticks

Here’s a quick and cheap way to make yourself some really good shooting sticks.  Start with 3 fiberglass driveway markers from the local hardware store.  These sticks are 4-foot long and approximately 1/4″ in diameter.  They are available at the local hardware store for about $2.00 each usually.

You also need some duct tape, preferably camouflage, and some cloth camouflage tape.  I like the Allen Company cloth camo tape, available on Amazon.  I use this type of cloth tape because the ligature will slide on it easily.

…and 36-inches of paracord.

sticks1

Start by unrolling a 48″ length of the duct tape, lay it sticky side up next to one of the sticks…

sticks2

 

…and roll it all the way around the stick keeping it as smooth and even as you can…

sticks3

 

…until the stick is completely covered.  This layer of tape helps to camouflage the sticks if the cloth tape wears off anywhere.  These sticks also have a nice point on one end which helps them stick into the ground.

sticks4

Step 2 is to lay a strip of the cloth tape, sticky side up next to the duct-taped rod as with the duct tape, BUT DON’T wrap it all the way around.

sticks5

the cloth tape goes edge to edge to leave a lengthwise seam that protrudes from the stick:

sticks6

This seam is necessary to hold the ligature in place and prevent it from sliding off of the sticks.  When all 3 sticks are thus taped, lay them together and cut a piece of paracord about 36-inches long.  Tie a tight not at each end and melt the ends to keep them from fraying.  CAUTION: the hot, melted paracord will stick to your skin and burn you if you touch it before it cools.   Form the paracord into a “U” and lay the three sticks across it:

sticks8

 

Tie a clove hitch in the paracord:

sticks9

The continue to tie half-hitches in each direction on the sticks:

sticks10sticks11sticks12sticks13

Keep tying until you have 8 loops around the sticks (4 hitches):

sticks14

Now it’s time to tie knots in the loose ends:

sticks16 sticks17 sticks18

In the end, you should have something that looks like this:

sticks19

 

You can slide the ligature up and down the rods by pushing it from the end opposite the direction you want to slide it.  When the hitches are pushed together, the knot loosens and can slide.  By pulling the ends of the knot, you can cinch it down, which will hold the sticks together and keep things from sliding:

sticks20

To use the sticks,  just push the coils together and spread the legs out into a tripod of the desired height:

sticks21

 

That’s it!  You now have some strong, flexible, lightweight shooting sticks.

 

 

 

 

 

 

 

 

 





One thought on “DIY Shooting Sticks

  1. Pingback: Shooting Sticks for Competition Use

Leave a Reply

Your email address will not be published. Required fields are marked *



Fresh ADC Articles:

Our instructors have a wide breadth of knowledge. Tap into some great info in blog and articles section.

Range Estimation Brain Teaser – Part II

Well, a few months ago when I wrote the last article, I had a few tests I decided to run at our spring Precision...

Range Estimation Brain Teaser

I suppose it is in my nature to try and resolve certain observed phenomena down to the mathematical formulae that can reliably and logically...

HOW TO USE ALL THE ADJUSTMENTS

Some of mankind’s first applications of the principles of ergonomics were with weapons. It probably started with the smoother rock,and evolved into the club...